Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3
Using the Appliance
3.1 Using 3 SPD Digital
Products
1. Press this button to turn on the appliance, the
product will operate at speed level 1, when this
button is pressed.
2. the product will operate at speed level 2, when
this button is pressed.
3. by exploring the display, you may follow which
speed the product operates at on it.
4. the product will operate at speed level 3, when
this button is pressed.
5. Press this button to switch the lamp on and off.
6. by pressing and holding any engine operating
button for more than 2 seconds, a 15 minutes
timer function will be initiated. a signal will be
displayed as soon as the chronometer starts,
and the engine will automatically stop after 15
minutes.
3.2 Recommendations for
Energy Saving
Your new appliance is exclusively
designed for energy saving. here
you may find several recommen-
C
dations on how to save more ener-
gy while using your appliance and
several devices necessary for using
your appliance appropriately.
• Make sure that there is an adequate air inlet to
allow your product to operate efficiently and
with a low operating noise.
• Adjust the fan speed according to the intensity
of the vapors in the kitchen. use the intense
Hood / User Manual
settings only if needed. a lower fan speed set-
ting means lower energy consumption.
• If there is a high amount of smoke in the kitchen,
select a higher fan speed. the hood must oper-
ate for a longer period in order to eliminate the
smoke already spread in the kitchen.
• Turn off the hood when not in use.
• Clean or replace the filter within the specified
time intervals in order to increase the efficiency
of ventilation and to avoid a fire hazard.
3.3 Cleaning Time for the
Metal Filter:
Filters must be cleaned when the signal „c" is dis-
played on the screen or (depending on the use)
after 2 or 3 weeks. in order to clear the "c" signal,
after the filters have been cleaned and replaced,
press and hold the button (
seconds (when the device is turned off). the letter
"e" will appear on the screen, and the appliance
will operate normally. if operations are necessary
before clearing the letter "c", then the active en-
gine speed will appear for 1 second when you
press the (
) button and then the engine will
resume functioning.
C
the "c" symbol will be displayed af-
ter 60 hours of functioning.
) for more than 3
9 / EN
Publicité
Table des Matières
