Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
6 OPERATION
NOTE: read and understand all Warning and Caution statements in this operation manual prior to
using this meter. Set the function select switch to the OFF position when the meter is not in use.
6.1 AC Current Measurements
WARNING: Ensure that the test leads are disconnected from the meter before making current
clamp measurements.
-
Set the function switch to the 1000 A, 600 A or 60 A range. If the approx. Range of the meas-
urement is not known, select the highest range then move to the lower ranges if necessary.
-
Press the REL button to zero the meter display.
-
Use the MODE button to select AC or DC current.
-
Press the trigger in jaw. Fully enclose only one conductor. For optimum results, centre the
conductor in the jaw.
-
The clamp meter LCD will display the Reading.
6.2 AC Voltage Measurement
-
Insert the black test lead into the negative COM terminal and the red test lead into the posi-
tive V
CAP TEMP Hz Ω terminal.
-
Set the function switch to the V~position.
-
Connect the test leads in parallel to the circuit under test.
-
Read the voltage measurement on the LCD display.
6.3 DC Voltage Measurement
-
Insert the black test lead into the negative COM terminal and the red test lead into the posi-
tive V
CAP TEMP Hz Ω terminal
-
Set the function switch to the V~position.
-
Connect the test leads in parallel to the circuit under test.
-
Read the voltage measurement on the LCD display.
6.4 Resistance
-
Insert the black test lead into the negative COM terminal and the red test lead into the V
CAP TEMP Hz Ω.
-
Set the function switch to the Ω.
-
Touch the test probes tips across the circuit r component under test.
-
Read the resistance on the LCD display.
CAP position.
KPA-01T
CLAMP METER TRMS
33 / 50
Publicité
Table des Matières
