Ac Current Measurements; Cleaning And Storage; Battery Replacement - koban KPA FLEX-01 Mode D'emploi

EN
4 OPERATION

4.1 AC Current Measurements

According to the power switch, turn on the instrument power supply, insert the output line of the meter into
the output line of the meter into the input end of the high precision digital universal meter with AC voltage
measurement function. Pre estimate the size of the current, to obtain the best output signal, to choose a good
measurement of gear. Single phase and then measured the ring into the flexible coil, placed in the central po-
sition and completely closed. This can be converted to obtain the magnitude of the current value.
5 MAINTENANCE
5.1

Cleaning and Storage

Clean periodically wipe the case with a clamp cloth and mild detergent, do not use abrasives or solvents. If the
meter is not being used for 60 days or more, remove the battery and store it separately.
5.2

Battery Replacement

- When the battery capacity is more than 2.5V, the power indicator light is green.
- When the battery capacity is about less than 2.5V, the power indicator is red.
- Need to replace the battery in time.
- Remove the Philips head screw that secures the rear battery door.
- Open the battery compartment.
- Replace two AAA batteries.
- Secure the battery compartment.
- Fix the screw the battery compartment.
KPA FLEX-01
AC FLEXIBLE CLAMP
10 / 14