Modify The Device Configuration - Mectron Piezosurgery plus Mode D'emploi Et D'entretien

Confirm the desired settings by pressing
the OK button;
The foot pedal button
indicating that the channel is ready for
use.
Press the foot pedal to start the
treatment. The foot pedal button starts
to blink, indicating that the device is
working properly.
4.12 Modify the Device Configuration
NOTE: While the device is operating, the
configuration options are disabled.
MODIFY INSERT SETTINGS
To change the IRRIGATION and POWER
settings, press the "-" and "+" buttons.
Proceed with the step 5 described in
Chapter 4.11 on page 25.
To deactivate the channel and to maintain
the current settings, press the foot pedal
button;
CAUTION: Selecting a new insert,
the settings of the insert currently
being used will be lost. To retrieve the
settings of the previous insert, it will be
necessary to select it again. The default
settings will be the ones preset by the
manufacturer.
26
5
6
is shown,
1