Mectron Piezosurgery plus Mode D'emploi Et D'entretien page 52

Information Message
These conditions indicate the presence
of an anomaly; the device continues to
operate, but with limited functionalities.
The messages are displayed periodically,
one by one, with the identifier of the
current message and the indication of
the total number of anomalies detected.
Error Message
MED - 001
Replace the handpiece.
MED - 002
Replace the handpiece.
MED - 004
Please check that the
handpiece is used properly.
If the problem persists,
replace it.
MED - 005
Tighten the insert tip.
If the problem persists,
replace the handpiece.
MED - 006
Internal problem.
"SHUTDOWN" the device
then start it again.
MED - 016
Channel out of use.
MED - 017
Make sure that the pump
and tube are correctly
installed
44
3
Actions Required
Replace the handpiece.
Replace the handpiece.
Please check that the
handpiece is used properly.
If the problem persists,
replace it.
1. Tighten the insert.
2. If the problem persists,
replace the handpiece.
3. If the problem persists,
replace the insert.
4. If the problem persists,
dry the electrical
contacts by blowing
compressed air.
"SHUTDOWN" the device
then start it again.
Use the channel that works.
Contact technical assistance.
Make sure that the pump
and tube are correctly
installed.
Make sure there is nothing
impeding the pump's
rotation.
Description
Malfunction of the tuning
circuit or faulty handpiece.
Malfunction of the tuning
circuit or faulty handpiece.
Malfunction of the tuning
circuit or faulty handpiece.
Insert not properly fastened
onto the handpiece.
Drop of the handpiece
electrical insulation.
Insert worn, broken or
deformed.
In rare cases, the presence
of humidity in the electrical
contacts of the cord may
occur.
Intervention of the out-
of-range supply voltage
protection.
Communication with the
channel module failed.
Failure in pump functionality.