Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The line engagement code is useful when the telephone is connected to a PABX
and is used to set the engagement code for the external line in the PABX.
This code, followed by a pause, is automatically dialled when you call a
number from the list of incoming calls with the "UP"/ "DOWN" and
"REDIAL" keys.
Note: This programming is not necessary if you want to set "0" as
line engagement code. Simply hold the "REDIAL" key
pressed for two seconds after the number you want to call is
displayed. (See page 82 )
Set brightness
After the "Set IP mode" programmation "SET 4 LCD" on the display for ten
seconds is displayed. In case you do not push any key within these ten seconds,
you have to push again the "SET" key and the "UP" or "DOWN" ones till
"SET 4 LCD" is displayed.
Press "SET" key to confirm. "LCD X" is displayed.
X (1, 2, 3, 4, 5, 6, 7, 8) is selected with "UP" or "DOWN" key.
Press "SET" key again to confirm the setting.
Flash time
The phone sends a line disengagement impulse to the telephone switch when
the FLASH key is pressed to put the call on hold. The FLASH time indicates
the impulse duration. The FlyViewOperator flash time default value is 100 mx
and is not programmable.
Note: The set of flash time made through the menù does not have
some effect.
Set Anti-intruision function
The anti-intrusion function prevents from using another telephone connected in
parallel to the FlyViewOperator telephone.
When this function is active, the FlyViewOperator telephone generates an
interference signal that prevents the telephone connected in parallel from
listening to the conversation or use the line for external calls.
INSTALLATION
73
Publicité
Table des Matières
