Set The Line Engagement Code; Set Brightness - Esse-ti ST 400 D Mode D'emploi Pour L'utilisateur

Set the line engagement code

After the "Area Code" programming "SET 3 PCODE" on the display for ten
seconds is displayed. In case you do not push any key within these ten seconds,
you have to push again the
PCODE" is displayed.
Press
code can be set now.
Press
Press
The line engagement code is useful when the telephone is connected to a PABX
and is used to set the engagement code for the external line in the PABX.
This code, followed by a pause, is automatically dialled when you call a
number from the list of incoming calls with the
Note: This programming is not necessary if you want to set "0" as
line engagement code. Simply hold the "REDIAL" key
pressed for two seconds after the number you want to call is
displayed. (See:"Call back" pag 66)

Set brightness

After the "Set IP mode" programming "SET 4 LCD" on the display for ten
seconds is displayed. In case you do not push any key within these ten seconds,
you have to push again the
LCD" is displayed.
Press
X (1, 2, 3, 4, 5, 6, 7, 8) is selected with
Press
58
key to confirm. "-" appears to indicate that line engagement
or keys to set the digit (1~9, *, # code).
key to confirm.
key to confirm. "LCD X" is displayed.
key again to confirm the setting.
key and the
key and the
e
or ones till "SET 3
,
and keys.
or ones till "SET 4
key.
INSTALLATION