Putting A Call On Hold When Connected To A Pabx; Accessing The Provider's Services; Ce Conformity Declaration - Esse-ti ST 400 D Mode D'emploi Pour L'utilisateur

Putting a call on hold when connected to a PABX

When ST400-D is connected to a PABX, you have to press the R key in order
to put a call on hold.
Press the
The call has now been put on hold and you can access all the PABX services.
Do not use the HOLD key to put the call on hold.
The only function of the HOLD key is to turn off
the handset microphone momentarily (the external
user receives waiting music). However, the operator
cannot forward the call to another extension or
access the telephone switch services. Moreover, the
call is cleared if you press the HOLD key twice

Accessing the provider's services

When ST400-D is directly connected to the trunk line (not to a PABX), R key
allows you to access the telephone network provider's services (Call Waiting,
Conference...). Please ask the provider for a list of the available services.
CE
CONFORMITY DECLARATION
Esse-ti s.r.l., with registered seat in Zona Ind. Squartabue, I-62019 Recanati
(MC), Italy, hereby declares that this device complies with the following
standards:
•
EN50082-1, EN55022
•
EN41003, EN60950
and also with the requirements of the 1999/5/CE Directive issued by the
European Parliament and by the Council on 9 March 1999 on radio sets,
telecommunication terminals and the mutual acknowledgement of their
conformity.
Compliance with the above requirements is shown with
TELEPHONE OPERATION
key during conversation.
Warning!
(Electromagnetic compatibility)
(Electric safety)
.
69