Esse-ti FlyViewOperator Mode D'emploi Pour L'utilisateur page 70

and RED LED for extension number.
The telephone starts scanning the L1-L7 LED's horizontally for the exchange
type.
When the LED of the desired exchange turns on, press the programming
button shortly.
The telephone starts scanning the red LED's vertically. LED 1 corresponds to
extension number 1, LED 2 to extension number 2, etc. Please see the
following guides for correctly choosing the extension number:
GUIDE FOR THE SELECTION OF THE EXTENSION NUMBER FOR
EUROPA, TA28, CT312 AND CT416:
The extension number is the PROGRESSIVE number of the extension
connected to the telephone. For example, the number of extension for extension
41 is 1, for extension 49 is 9, for extension 51 is 10, etc...
GUIDE FOR THE SELECTION OF THE EXTENSION NUMBER FOR
POLARISPLUS, SMILEPLUS, FOX70, FOX90, CT624
The extension number is a number from 1 to 8 according to the position of the
extension in the extension board. For example, the extension number of the
fourth extension of the extension board is 4.
When the LED of the extension number you want to assign to the
telephone turns on, press the programming button shortly.
Programming is completed and the telephone returns to the idle state.
Note: If you press the programming button for more than 2 seconds,
the telephone rapidly scans all LED's. The telephone cannot
be programmed in this phase. Press the programming button
shortly to return to the idle state.
Note: To exit programming without saving the modifications press
the programming button for about 2 seconds.
Example:
•
Exchange type: CT416K
70
L6 CT312K
L7 CT416K
INSTALLATION