Grass Trimmer Safety Warnings - Ryobi RBC254SESO Manuel D'utilisation

secure the product from moving before transporting in
a vehicle.
■ Always stop the engine and make sure all moving
parts have come to stop before:
● servicing
● leaving the product unattended
● cleaning your product
● changing accessories
● clearing blockages
● checking for any damage after hitting an object
● checking for any damage if the product starts to
vibrate abnormally
● performing maintenance
● removing blade
● installing blade
WARNING
Never use cutting means or attachments, which are not
specified by Ryobi in this manual. This includes the use of
metal multi-piece pivoting chains and flail-blades. These
items are known to break up during use and present a
high risk of serious injury to the operator or bystanders..
WARNING
Inspection after dropping or other impacts: Thoroughly
inspect the product and identify any problems or damage
to it. Any part that is damaged should be properly
repaired or replaced by an authorised service centre.

GRASS TRIMMER SAFETY WARNINGS

■ Replace the string head if cracked, chipped, or
damaged in any way. Be sure the string head is
properly installed and securely fastened. Failure to do
so can cause serious injury.
■ Avoid using on wet grass.
■ Do not walk backwards when using the product.
■ Walk, never run.
■ The small blade fitted to the cutting attachment guard
is designed to trim the new extended line to the correct
length for safe and optimum performance. It is very
sharp; do not touch it, particularly when cleaning the
product.
■ Always ensure that ventilation openings are kept clear
of debris.
■ Before use and after any impact, check that there
English (Original instructions)
■ Make sure the head attachment is properly installed
■ Make sure all guards, deflectors, handles, bolts, and
■ Do not modify the product in any way. This may
■ Use only the manufacturer's replacement line in the
■ Never use the product without the cutting attachment
■ Maintain a firm grip on both handles while trimming.
BRUSHCUTTER SAFETY WARNINGS
■ In addition to the above rules, these additional
■ Use heavy-duty gloves while installing or removing the
■ Do not attempt to touch or stop the blade when it is
■ A moving blade can cause severe injury. Maintain
■ Replace any blade that has been damaged. Always
■ Use only the manufacturer's replacement Tri-Arc™
■ Never cut any material over 13 mm diameter.
■ Your brushcutter is fitted with a harness. Carefully
■ Identify the quick release mechanism and practice
■ Cover the blade with the blade protector before storing
25
are no damaged parts. Examine the cutting means
for signs of cracking or other damage. A defective
switch or any part that is damaged should be properly
repaired or replaced by an authorised service facility.
and securely fastened.
fasteners are properly and securely attached.
increase the risk of injury to yourself or others.
cutting head. Do not use any other cutting attachment.
guard in place and in good condition.
Keep string head below waist level. Never cut with
the string head located over 76 cm or more above the
ground.
instructions are appropriate when using the product in
brushcutter mode.
blades, they have sharp edges.
rotating.
proper control of the product with both hands until the
blade has completely stopped rotating.
make sure the blade is installed correctly and securely
fastened before each use.
blade. Do not use any other cutting attachment.
adjust the harness to fit comfortably and help to
support the weight of the product at your right side.
using it before you start using the product. Its
correct use may prevent serious injury in case of
an emergency. Never wear additional clothing over
the harness or otherwise restrict access to the quick
release mechanism.