Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.1.3
Tank height
The arrow at the bottom of the display points to the unit Percent. The
display shows the tank height adjusted. The value 0000 means that no
tank height has yet been entered.
1. Use the two programming keys to enter the determined tank height in
mm. Press the programming key (arrow up) to select the digit to be
changed. Then press the programming key (arrow down) to change the
value of the selected digit.
2. Press the function key to confirm the setting. After that, you can enter
the liquid level.
6.1.4
Current liquid level
The arrow at the bottom of the display points to the unit Level (FH). The
display shows level measured by the probe in mm.
The value shown on the display is based on the tank data you have
already entered and on the measurement. Check whether the displayed
value corresponds to the value you have determined in
chapter "Determining the tank data" to a degree of accuracy that is suffi-
cient for your purposes. If you want to obtain a higher accuracy, you can
overwrite the displayed liquid level by the actual liquid level as determined
by you.
The higher the filling level at the point in time the tank data is entered, the
higher the accuracy. The highest accuracy is achieved if the tank is com-
pletely full when you enter the tank data. If the actual liquid level is less
than 50 %, it is not meaningful to correct the displayed value. In such a
case, you can re-enter the tank data when the tank is completely full, see
chapter "Correcting the adjusted tank data".
1. Use the two programming keys to enter the determined liquid level in
mm. Press the programming key (arrow up) to select the digit to be
changed. Then press the programming key (arrow down) to change the
value of the selected digit.
2. Press the function key to confirm the setting.
You have now entered all the tank data and the control unit switches to
normal measurement mode.
- The symbol (both arrows) is no longer displayed in the top left corner of
the display.
Commissioning
EN
21
DIT 10
Publicité
Table des Matières
