Ingeteam INGEREV FUSION Série Manuel D'installation Et Usage page 27

Installing the unit
5. From inside the charger, fasten it using the supplied bolt and washer in the indicated hole.
6. Check that the fastening is correct.
7. Insert the cabling through the accesses in the lower part of the station (see sections "2.7. Cabling
accesses" and "8.3. Power supply connection process").
8. Remove the protective film from the panel.
Once the unit has been installed correctly, the connection process will begin. Make the connections in the
following order:
1. Connection of accessories (optional).
2. AC connection.
ABW2011IQM01_D - Installation and Operation Manual
Ingeteam
EN
ES
FR
IT
PT
27