Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
FUSE REPLACEMENT
1.
Engage the parking brake (7, Fig. E).
2.
Turn the ignition key (17, Fig. D) counterclockwise, to
the end of stroke, then remove it.
3.
Remove the transparent cover of the fuse box (24 or 25,
Fig. D) and replace the relevant fuse:
Fuse box B (24, Fig. D)
a.
Hazard warning light fuse (10 A)
b)
Brake light/horn fuse (10 A)
c)
Left side running light fuse (10 A)
d)
Right side running light fuse (10 A)
e)
Low beam fuse (15 A)
f)
High beam fuse (15 A)
g)
Cigarette lighter fuse (20 A)
h)
Free fuse holder
Fuse box A (25, Fig. D)
i)
Hydraulic system oil cooler fan/skirt solenoid valve fuse
(20 A)
j)
Fuel solenoid valve fuse (10 A)
k)
Cab blower/flashing light/windscreen wiper fuse (15 A)
l)
Dust control system water pump fuse (10 A)
Dust control system water pump/climate control system
fuse (20 A)
m)
Reverse gear buzzer fuse (10 A)
n)
Warning lights/glow plug control unit fuse (10 A)
o)
Electric jack warning light fuse (10 A)
p)
Hopper lid opening/closing electric jack fuse (15 A)
4.
Install the transparent cover of the fuse box (24 or 25,
Fig. D).
30
All manuals and user guides at all-guides.com
WINTER MAINTENANCE
In winter, perform the following maintenance procedures
carefully.
Procedures for machine storage or for machines working
at less than 0°C
1.
2.
3.
4.
5.
6.
Procedures to perform when the machine has been
stored for two months
1.
2.
3.
4.
5.
Procedures to perform when the machine has been
stored for three months
1.
2.
Drain the nozzles and water tanks.
Drain and clean/replace the water filter.
Pour antifreeze in the water tanks (check the quantity).
Turn on the water pump (see the procedure in the
relevant paragraphs) to let the antifreeze flow through
the system until it comes out from the broom nozzles,
from the suction hose nozzle and from the rear pipe
nozzle (if equipped).
When the antifreeze comes out from the nozzles, stop
the pump.
Start the diesel engine as shown in the relevant
paragraph.
Turn on the high-pressure washing system pump (see
the procedure in the relevant paragraphs) and let the
antifreeze flow through the high-pressure washing
system until it comes out of the water gun.
When the antifreeze comes out, stop the pump.
WARNING!
Do not use the dust control system when the
outside temperature is lower than 0°C because
it can create ice sheets on the roadbed.
Replace the engine oil and oil filter (see the relevant
paragraphs).
Fill the fuel tank (see the relevant paragraph).
Apply grease.
Charge the battery.
Check the wheel pressure (see the relevant paragraph).
Perform the same procedures of the second month.
Each month connect a battery charger and keep the
battery charged for 12/24 hours.
33015501(2)2006-10 A
Publicité
Table des Matières
Dépannage
