Dust Control System Nozzle And Filter Cleaning - Nilfisk Advance RS 501 Manuel D'utilisation

USER MANUAL
Suction pipe cleaning (after every use)
6. Thoroughly clean the suction pipe (27, Fig. F) inside, up
to the suction inlet, with pressurized water.
7. Carefully check the suction pipe gasket (31, Fig. F) for
integrity, and replace it if necessary.
Suction filter cleaning (after every use)
8. Inside the hopper, remove the suction filter fastener (1,
Fig. P).
9. Remove the suction filter (2).
10. Clean the deflector (3, Fig. P) and the fan (4) with
pressurized water. Check that all fan sectors (5) are
clean.
11. Clean the suction filter (2, Fig. Q) with pressurized water
(1).
12. Install the suction filter (2, Fig. P) and secure it with the
retainer (1).
13. Remove the lid support rod (8, Fig. F) and lower the
hopper (12, Fig. G) according to the instructions shown
in the relevant paragraph.
14. Turn off the engine, by turning the ignition key (17, Fig.
D) counterclockwise, to the end of stroke, then remove
it.
Breather filter cleaning (after every use)
15. With a ladder and the help of an assistant, disengage
the fasteners (29, Fig. G) of the breather filter hood (28).
16. Open the hood (1, Fig. R) and install the safety pins (2).
17. Remove the mounting screws (1, Fig. S), then remove
the breather filter (2).
18. Clean the breather filter (2, Fig. T) with pressurized
water (1).
19. Install the breather filter and its hood performing steps
from 15 to 17 in reverse order.
22
All manuals and user guides at all-guides.com
DUST CONTROL SYSTEM NOZZLE AND
FILTER CLEANING
Preliminary operations
1.
2.
Cleaning of nozzle and filter in the rear suction pipe
3.
4.
5.
6.
Cleaning of nozzles and filters on brooms
7.
8.
9.
Cleaning of nozzles inside the suction inlet
10.
11.
12.
13.
WARNING!
Protect body parts (eyes, hair, hands, etc.)
properly, when performing cleaning
operations using compressed air or water gun.
Engage the parking brake (7, Fig. E).
Turn the ignition key (17, Fig. D) counterclockwise, to
the end of stroke, then remove it.
Remove the screw (1, Fig. U) together with the nozzle
(2) and the filter (3).
Remove the nozzle (2, Fig. U) and the screw (1), then
remove the filter (3).
Clean the nozzle (1, Fig. V) and filter (3) with
compressed air. Remove calcium deposits. If
necessary, replace the filter (3).
Install the filter, the nozzle and the screw in the reverse
order of removal.
Unscrew the ring nuts (1, Fig. V).
Clean the nozzles (2, Fig. V) and filters (3) with
compressed air. Remove calcium deposits. If
necessary, replace the filters (3).
Install the filters and nozzles, and secure them with the
ring nuts. Nozzle holes must be directed down when
tightening.
On both sides of the suction inlet (1, Fig. W), remove the
screws (2) together with the nozzles (3).
Remove the nozzles (3, Fig. W) from the crews (2).
Clean the nozzles (3, Fig. W) with compressed air.
Remove calcium deposits.
Install the nozzles and screws in the reverse order of
removal.
33015501(2)2006-10 A