Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. PREPARE THE INSTALLATION
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
Make sure that the following items are included:
- Power Pack
- Accessories:
• 2 Filters
• 2 Filter knobs with screws, taped inside power pack
• 3¼" x 10" adapter/damper (supplied with 600 CFM single blower power pack)
• 10" round in-line vertical damper (supplied with 1000 CFM dual blower power pack)
• 10" round adapter (supplied with 1000 CFM dual blower power pack)
• Bag of parts including: 1 wire clamp, 2 wire connectors, 4 no. 8 x 3/8" screws, 9 no. 8 x 1/2" chrome plated screws,
10 no. 8-32 x 1/4" screws. If need be, discard extra hardware.
Parts sold separately:
- Custom hood liner model ALCC630SB, ALCC636SB or ALCC642SB (optional)
- Ducts, elbows, wall and roof caps. Refer to page 3 for a complete list of venting options and model numbers.
NOTE: During installation, protect countertop and/or cooktop.
2. INSTALL DUCTWORK AND ELECTRICAL WIRING
Plan where and how the ductwork will be installed. Access to the top of the power pack is preferred for connection of ductwork.
Install proper-sized ductwork, elbows and roof or wall cap for the type of power pack you are installing. If installing CC65I28SB single
blower power pack, use 3¼" x 10" ductwork. If installing CC67I28SB double blower power pack, use 10" round ductwork. Use 2" metal foil
duct tape to seal duct joints.
We recommend to install the power pack at a minimum distance of 24" from an electric range and 30" from a gas range.
Distances over 30" are at the installer and users discretion.
Run 3-wire power supply cable to installation location. Its length should extend at least 4 feet below the bottom of the custom hood.
Roof cap
Wall
cap
HH0116A
(
SINGLE BLOWER
NOTE: Although the horizontal discharge installation is feasible with CC65I28SB power pack model, this installation type
should be performed in specific situation only since it requires particular knowledge and technical skills from the installers.
3¼" x 10" duct
3¼" x 10"
adapter & damper
Power pack
24" minimum above
cooking surface
(30" for gas range)
M
CC65I28SB
ODEL
) T
D
YPICAL
UCTWORK
WARNING
!
Wall
cap
HH0117A
(
DUAL BLOWER
4
Roof cap
10" round duct
10" in-line
vertical damper
10" round elbow
10" round adapter
Power pack
24" minimum above
cooking surface
(30" for gas range)
M
CC67I28SB
ODEL
) T
D
YPICAL
UCTWORK
Publicité
Table des Matières
