Functional Description; Intended Use - Bosch GCO 2000 Professional Notice Originale

OBJ_BUCH-385-005.book Page 8 Friday, October 17, 2008 10:39 AM
8 | English
Keep hands away from the cutting area
while the machine is running. Danger of in-
jury when coming into contact with the cut-
ting disc.
Never remove cutting remainders, metal
chips, etc. from the cutting area while the
machine is running. Always guide the tool
arm back to the neutral position first and
then switch the machine off.
Guide the cutting disc against the work-
piece only when the machine is switched
on. Otherwise, there is danger of kickback,
when the cutting disc becomes wedged in
the workpiece.
Operate the power tool only when the work
area to the workpiece is clear of any adjust-
ing tools, metal chips, etc. Small pieces of
metal or other objects that come in contact
with the rotating cutting disc can strike the
operator with high speed.
Always firmly clamp the workpiece. Do not
cut workpieces that are too small to clamp.
Otherwise, the clearance of your hand to the
rotating cutting disc is too small.
Pay attention that persons are not put in
danger by sparking. Remove any combusti-
ble materials in the vicinity. Sparks develop
when cutting metal.
Use the cut off grinder only for cutting ma-
terials mentioned under "Intended Use".
Otherwise, the cut off grinder can be subject
to overload.
Do not use damaged, out-of-center or vi-
brating cutting discs. Damaged cutting
discs cause increased friction, binding of the
cutting disc and kickback.
Always use cutting discs with correct size
and shape (diamond versus round) of arbor
holes. Cutting discs that do not match the
mounting hardware of the cut off grinder will
run eccentrically, causing loss of control.
Do not touch the cutting disc after working
before it has cooled. The cutting disc be-
comes very hot while working.
1 609 929 S36 | (17.10.08)
All manuals and user guides at all-guides.com
Symbols
The following symbols may be of meaning for
the use of your power tool. Please take note of
the symbols and their meaning. The correct in-
terpretation of the symbols will help you to use
the machine in a better and safer manner.
Symbol

Functional Description

Intended Use

The machine is intended for stationary use with
cutting disks to perform lengthways and cross-
ways straight cuts or mitre cuts to 45° in metal
materials without the use of water.
Meaning
Danger area! Keep hands,
fingers or arms away from
this area.
Wear safety goggles.
Wear hearing protection.
Exposure to noise can
cause hearing loss.
Wear a dust respirator.
Wear protective gloves.
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
Bosch Power Tools