ABB ACS55 Guide De L'utilisateur page 295

6. Actual signals and
parameters in the short view
Note: When the control panel is in the short parameter view, ie when parameter
PARAMETER VIEW
subset of all signals and parameters. These signals and parameters are described in
this chapter.
To be able to view all actual signals and parameters, set parameter
PARAMETER VIEW
parameters, refer to chapter Actual signals and parameters in ACS310 user's manual
(3AUA0000044201 [English]).
Terms and abbreviations
Term Definition
Actual signal Signal measured or calculated by the drive. Can be monitored by the user.
No user setting possible. Groups 01...04 contain actual signals.
Def Parameter default value
Parameter A user-adjustable operation instruction of the drive. Groups 10...99 contain
parameters.
Note: Parameter selections are shown on the Basic control panel as integer
values. Eg parameter 1001 EXT1 COMMANDS selection COMM is shown as
value 10 (which is equal to the fieldbus equivalent FbEq).
FbEq Fieldbus equivalent: The scaling between the value and the integer used in
serial communication.
E Refers to types 03E- with European parametrization
U Refers to types 03U- with US parametrization
Fieldbus equivalent
Example: If 2008 MAXIMUM FREQ
system, an integer value of 1 corresponds to 0.1 Hz. All the read and sent values are
limited to 16 bits (-32768...32767).
Actual signals and parameters in the short view 27
is set to 2 (SHORT
to 3 (LONG VIEW). For the description of all actual signals and
(see page 31) is set from an external control
VIEW), the control panel only shows a
1611
1611