ABB ACS55 Guide De L'utilisateur page 287

5. Start-up and control with I/O
How to start up the drive
WARNING! The start-up may only be carried out by a qualified
electrician.
The safety instructions given in chapter
start-up procedure.
The drive will start up automatically at power up if the external run command is on
and the drive is in the remote control mode.
Check that the starting of the motor does not cause any danger. De-couple the
driven machine if there is a risk of damage in case of incorrect direction of rotation.
Note: By default, parameter
and you cannot see all actual signals and parameters. To be able to view them, set
parameter 1611 PARAMETER VIEW
• Check the installation. See the checklist in section
18.
How you start up the drive depends on the control panel you have.
• If you have a Basic control panel, follow the instructions given in section
perform a manual start-up
• If you have an Assistant control panel, you can either run the Start-up assistant
(see section How to perform a guided start-up
start-up (see section
The Start-up assistant, which is included in the Assistant control panel only,
guides you through all essential settings to be done. In the manual start-up, the
drive gives no guidance; you go through the very basic settings by following the
instructions given in section
Safety
1611 PARAMETER VIEW
to 3 (LONG
on page 20.
How to perform a manual start-up
How to perform a manual start-up
Start-up and control with I/O 19
on page 5 must be followed during the
is set to 2 (SHORT
VIEW).
Installation checklist
on page 23) or perform a manual
on page 20).
on page 20.
VIEW),
on page
How to