Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en - Notes
Fault messages
When a fault occurs, ironing is interrupted, the button flashes, and a four-digit code ap-
pears in the display. Pressing the flashing button acknowledges the fault (the fault is
stored in the fault memory). The button flashes and the ironing process can be
restarted.
Fault code
Fault
Heater fault
Electronic fault
Drive fault
Fan fault
Electronic fault
Appliance blocked
Drive voltage too low
General compressor fault
Low voltage
–
Control system fault
If the fault message appears again, repeat the process or switch the iron off before switch-
ing it back on again. If the fault persists, contact Miele Technical Service.
In the event of a malfunction, contact Miele Technical Service.
30
Publicité
Chapitres
Table des Matières
