Camera To Card' Transfer - THOMSON OCP 42 Manuel D'utilisation

176
- 1 to 24: the settings stored for camera x (where x is between 1 and 24) will be transferred
to the cameras selected on the MSP, regardless of their number.
- NO STUDIO: wrong card type.
- NO FILE: blank card.
- NO CARD: no card present in the card reader.
• WRITE CAM: selecting this function using the corresponding operating key has the
following effect:
- With an OCP 50: transfers the settings indicated and selected in 'TFR TYPE' and 'CARD
FILE' to the camera(s) selected using the MSP.
- With an OCP 42: transfers the settings indicated and selected in 'TFR TYPE' and 'CARD
FILE' to the camera connected to the equipment (the selection 'CARD FILE = STUDIO'
is not authorised).
During the writing, the following page displays:
• ABORT: selecting this function using the corresponding operating key returns you to the
previous page.

2.7.2.4 - 'Camera to card' transfer

In general terms, this function is used to store certain settings for a single digital type camera
on the card.
The call of the camera main transfert is made in the SETTING CAMERA:
THOMSON OCP 42/OCP 50
User manual
Chapter 2 -OCP 42/OCP 50 Operating Instructions
OCP 42/OCP 50 memory card & memory key
WR I T I NG CAME RA
I N P ROGR E S S . . . .
P l e a s e w a i t
OC P
x . x x
x . x x
SETTING
MS P
(OCP key)
RA T I O
4 / 3
1
LEN S F I L E
B L K S HAD
CAM CARD
CCU
x . x x
x . x x
CAME RA
GAMMA L AW
F AC T
E BU
MA S K . L AW
NEXT (OCP key)
D I AGNOS E
ME NU S
R E CA L L S T OR E
CAME RA CARD
B1500M24LA
September 2000