Description Of Indicator Lights - THOMSON OCP 42 Manuel D'utilisation

Chapter 2 - OCP 42/OCP 50 Operating Instructions

Description of indicator lights

2.4 - DESCRIPTION OF INDICATOR
LIGHTS
ON AIR 2: Lights when the equipment is on the secondary
antenna.
PREVIEW: Lights when the equipment video is selected
on the technical control room (engineer's) screens (via
external preselector). Refer to connector PREVIEW/AUX
in the Installation chapter of this manual.
ON AIR 1: Lights when the equipment is on the main
antenna.
NOTE: There are two operating modes for the panel
controls when ON AIR 1 is lit. Refer to the panel
setting up and installation chapter of this manual.
CTRL: Lights on an operator control if the latter is
accepted.
DIAG: Lights on an operator control if this is not accepted
(inoperative).
LIMIT: Lights subsequent to execution of a black balance,
if this is defective.
LIMIT: Lights:
• Subsequent to execution of a white balance (WHITE
BAL) if the latter is defective.
• Momentarily during
permanently if white balance defective.
ASSIGNED: Lit when the partial gain controls are assi-
gned to another function. E.g.: R, B GAMMA if the
GAMMA range is displayed.
ASSIGNED: Lit when the partial black controls are assi-
gned to another function. E.g.: R, G, B FLARE if the
BLACK range is displayed.
EXTENDER: Lights when the focal length multiplier on
the lens is other than x1.
B1500M24LA
September 2000
white balance execution,
PRE
ON AIR 1
VIEW
LOCK ACTIV CCU STATUS BARS
F1 F2 F3
EXIT
CTRL
DIAG
PRESET GAIN FILTERS DETAIL
STORE DFZ BLACK COLOUR
RECALL KNEE SHUTTER GAMMA
BLACK BAL
LIMIT
ASSIGNED ASSIGNED
GAIN
ASSIGNED
ASSIGNED
BLACK
ENABLE
THOMSON OCP 42/OCP 50
User manual
165
ON
AIR 2
SETTING CALL
F4
NEXT
SKIN MEMORY
WHITE BAL
LIMIT
FINE
ADJUST
AUTO IRIS
EXTENDER
IRIS
BLACK
LEVEL
OCP 42