THOMSON OCP 42 Manuel D'utilisation page 139

Chapter 2 - OCP 42/OCP 50 Operating Instructions
Description of pushbuttons
2.2.7.4 - BARS button
This button activates the various test signals. The test
signal available at the equipment output depends on some
of the «PM» monitoring settings (see CCU «SETTING
UP» in the Installation chapter of this manual).
Having selected the camera picture video:
• Press the button once to select the bar pattern video:
CCU 1685 CCU1686
- Camera bar pattern on analog and digital outputs if
«PM» monitoring setting is other than «ENC».
- Camera bar pattern on analog outputs and CCU
synthetic bar pattern on digital outputs if «PM»
monitoring setting is «ENC».
CCU 1542 APCM
- Camera bar pattern on outputs if «PM» monitoring is
other than «ENC».
- CCU bar pattern on «PM» monitoring outputs if
«ENC» selected.
CCU 1625 ou DT500
- Camera bar pattern at outputs whatever the «PM»
monitoring setting.
• 2nd operation of the button selects the test video:
CCU 1685 CCU1686
- Camera test video on analog and digital outputs if the
«PM» monitoring selected is other than «ENC».
- Camera test video on analog and CCU synthetic test
video on digital outputs if the «PM» monitoring setting
is «ENC».
CCU 1542 APCM
- Camera test video on outputs whatever the «PM»
monitoring setting.
CCU 1625/DT500
- Camera test video on outputs whatever the «PM»
monitoring setting.
• 3rd operation of the button is used to return to the
camera image video.
B1500M24LA
September 2000
PRE
ON AIR 1
VIEW
LOCK ACTIV CCU STATUS BARS
F1 F2 F3
EXIT
CTRL
DIAG
PRESET GAIN FILTERS DETAIL
STORE DFZ BLACK COLOUR
RECALL KNEE SHUTTER GAMMA
BLACK BAL
LIMIT
ASSIGNED ASSIGNED
GAIN
ASSIGNED
ASSIGNED
BLACK
ENABLE
THOMSON OCP 42/OCP 50
User manual
139
ON
AIR 2
SETTING CALL
F4
NEXT
SKIN MEMORY
WHITE BAL
LIMIT
FINE
ADJUST
AUTO IRIS
EXTENDER
IRIS
BLACK
LEVEL
OCP 42