THOMSON OCP 42 Manuel D'utilisation page 147

Chapter 2 - OCP 42/OCP 50 Operating Instructions
Description of pushbuttons
2.2.8.2 - GAIN button
Used to adjust the GAIN range settings.
Press the button to display the page below:
GA I N U P
GAI N DOWN
By pressing the GAIN UP or GAIN DOWN buttons, the
camera gain is increased or decreased.
2.2.8.3 - FILTERS button
Used to perform FILTER range adjustments. Press this
button to obtain the following page:
N . D DOWN
This page enables:
• N.D. UP - N.D DOWN: By pressing the corresponding
buttons, enables actuation of the filter wheel in either
direction. The position of the wheel and type of filter in
service are displayed.
• EFF. UP - EFF. DOWN: By pressing the corresponding
buttons, enables actuation of the filter wheel in either
direction. The position of the wheel and type of filter in
service are displayed.
2.2.8.4 - DETAIL button
Used to perform DETAIL range adjustments.
Press the button to display the following page:
D T L L E V E L
L E V E L D E P
This page is used to modify the following parameters:
• DTL LEVEL: Detail level setting.
• LEVEL DEP: Noise suppression on detail signal in the
dark parts of the picture.
• CORING: Detail signal noise reduction correct
adjustment can cause a blurred image.
B1500M24LA
September 2000
X X d B
N . D U P E F F . U P
C L E AR C L E AR
1 A
⇒ ⇒
E F F . DOWN
X X
X X X X
COR I NG
PRE ON AIR 1
VIEW
LOCK ACTIV CCU STATUS BARS
F1 F2 F3
EXIT
CTRL
DIAG
PRESET GAIN FILTERS
DETAIL
STORE DFZ BLACK COLOUR
RECALL KNEE SHUTTER GAMMA
BLACK BAL
LIMIT
THOMSON OCP 42/OCP 50
User manual
147
ON
AIR 2
SETTING CALL
F4
NEXT
SKIN MEMORY
WHITE BAL
LIMIT