THOMSON OCP 42 Manuel D'utilisation page 149

Chapter 2 - OCP 42/OCP 50 Operating Instructions
Description of pushbuttons
This page can be used to alter the following parameters:
• DFZ WIDE: Adjustment of detail level for the zoom
wide angle position.
• DFZ TELE: Adjustment of detail level for the zoom
telelens position.
• DFZ: DFZ function ON/OFF (ON/OFF switching is
made directly with the corresponding operating button).
2.2.8.6 - BLACK button
Used to enable adjustment of the BLACK range settings.
Press the button to display the 1st setting page. This page
depend on the partial black controls assignment. Refer to
the INSTALLATION chapter, 1.7.3 - Setting up the OCP
paragraph.
F L AR E R F L AR E G
X X X X
O F F X X
AB L F L AR E B
Controls assigned to
partial blacks
The three button indicator lights corresponding to the
FLARE or partial blacks settings light.
The ASSIGNED lights, indicating that the R, G, B partial
black control are assigned to this range, light.
This page is used to modify the following parameters:
• If the partial black controls ara assigned to partial black
level adjustments
- FLARE R: Red channel FLARE adjustment by
varying the red partial black control.
- FLARE G: Green channel FLARE adjustment by
varying the green partial black control.
- FLARE B: Blue channel FLARE adjustment by
varying the blue partial black control.
NOTE: The ADJUST control is used to adjust the
"MASTER" FLARE R, G, B.
B1500M24LA
September 2000
B L A C K R B L A C K G
or
X X
O F F
A B L B L A C K B
Controls assigned to
FLARE
VIEW
LOCK
EXIT
X X
X X
PRESET
STORE
RECALL
ENABLE
THOMSON OCP 42/OCP 50
149
PRE ON AIR 1 ON
AIR 2
ACTIV CCU STATUS BARS SETTING CALL
F1 F2 F3 F4
NEXT
CTRL
DIAG
GAIN FILTERS DETAIL
DFZ BLACK COLOUR
KNEE SHUTTER GAMMA SKIN MEMORY
BLACK BAL WHITE BAL
LIMIT LIMIT
ASSIGNED ASSIGNED
GAIN
ASSIGNED ASSIGNED
FINE
BLACK
ADJUST
AUTO IRIS
User manual