Display On Power On; Welcome Page; Warning Page - THOMSON OCP 42 Manuel D'utilisation

116

1.6 - DISPLAY ON POWER ON

1.6.1 - Welcome page

Switch on the equipment.
The welcome page is displayed.
This page indicates the panel software version:
After the connection is made between the Channel Control Unit and the camera, this page is
replaced by the STATUS 1 page (described in the OPERATING INSTRUCTIONS chapter of
this manual).
If the link is not made, the warning page is displayed.

1.6.2 - Warning page

Note: The OCP 50 warning page used with a MSP (centralized system) is described in
the MCP user manual.
If the link with the camera, or a fortiori with the CCU is not made, the following warning page
is displayed:
This page provides the following information:
• NO LINK: No communication with the CCU.
• NO CAMERA: No communication with the camera.
THOMSON OCP 42/OCP 50
User manual
Chapter 1 - OCP 42/OCP 50 Installation
T HOMSON
OC P
V e r s i o n X . X
: : : : : : : : :

Display on POWER ON

B1500M24LA
September 2000