Control Buttons - THOMSON OCP 42 Manuel D'utilisation

138

2.2.7 - Control buttons

Unless otherwise stated, the indicator light mentioned in
each button description is built into the button.
The operation pushbuttons mentioned correspond to the 4
buttons around the display.
2.2.7.1 - LOCK button
Indicator light lit: All the panel controls are disabled.
Indicator light off: All the panel controls are enabled.
Also see ACTIV and ENABLE buttons.
2.2.7.2 - ACTIV button
If the LOCK light is off, the ACTIV button:
• With indicator light lit: All the controls of the top part of
the panel are enabled (refer to ENABLE button for the
bottom part).
• Indicator light off: Only the following controls are
enabled:
- All potentiometers of the top part of the panel (refer to
the ENABLE pushbutton for the bottom part).
- Buttons: SETTING, EXIT, CALL, NEXT.
- Selection of operating ranges and internal settings of
these ranges with the exception of ON/OFF switching
functions.
2.2.7.3 - CCU STATUS button
Pressing of this button inlays the CCU operating status on
the «PM» monitoring output video status of the Channel
Control Unit.
Press this button again to disable inlay of the operating
status on the «PM» monitoring output of the Channel
Control Unit.
NOTE: This function is available on some types of
Channel Control Unit. Refer to the specific equipment
manual.
In VTR configuration control the VTR START/STOP.
THOMSON OCP 42/OCP 50
User manual
Chapter 2 -OCP 42/OCP 50 Operating Instructions
Description of pushbuttons
PRE
ON AIR 1
VIEW
LOCK ACTIV CCU STATUS BARS
F1 F2 F3
EXIT
CTRL
DIAG
PRESET GAIN FILTERS DETAIL
STORE DFZ BLACK COLOUR
RECALL KNEE SHUTTER GAMMA
BLACK BAL
LIMIT
ASSIGNED
ASSIGNED
GAIN
ASSIGNED ASSIGNED
BLACK
ENABLE
B1500M24LA
September 2000
ON
AIR 2
SETTING CALL
F4
NEXT
SKIN MEMORY
WHITE BAL
LIMIT
FINE
AUTO IRIS ADJUST
EXTENDER
IRIS
BLACK
LEVEL
OCP 42