Range Buttons - THOMSON OCP 42 Manuel D'utilisation

146

2.2.8 - RANGE buttons

The range buttons mentioned correspond to 4 buttons
located around the display.
2.2.8.1 - Presentation
These buttons are used to select a setting range.
• Selection of a range lights the corresponding range light.
This light remains lit as long a the range is displayed.
• Return to the reset page is obtained after a time defined in
the panel settings (refer to the INSTALLATION chapter
1.7.3 - Setting up the OCP paragraph) or by pressing the
EXIT button.
• Pressing of a range button while its light is lit causes
permanent display of this range. The range is cleared either
by:
- Pressing another range button.
- Pressing the EXIT button.
• Parameter modification (unless otherwise specified):
- Select the parameter range by pressing the
corresponding button (the range is displayed).
- Press the button located above or below the parameter
to be modified.
-If the parameter is a stepped parameter,
the button light remains off and the
parameter is modified directly.
- Press EXIT to display one of the rest pages.
THOMSON OCP 42/OCP 50
User manual
Chapter 2 -OCP 42/OCP 50 Operating Instructions
Description of pushbuttons
PRE
ON AIR 1
VIEW
LOCK ACTIV CCU STATUS BARS
F1 F2 F3
EXIT
CTRL
DIAG
PRESET GAIN FILTERS DETAIL
STORE DFZ BLACK COLOUR
RECALL KNEE SHUTTER GAMMA
BLACK BAL
LIMIT
ADJUST
B1500M24LA
September 2000
ON
AIR 2
SETTING CALL
F4
NEXT
SKIN MEMORY
WHITE BAL
LIMIT