THOMSON OCP 42 Manuel D'utilisation page 145

Chapter 2 - OCP 42/OCP 50 Operating Instructions
Description of pushbuttons
• Return to the rest page is made after a period defined in
the panel settings (refer to the Installation part of this
manual) or by pressing the EXIT button.
• Pressing RECALL again while the corresponding page is
already displayed causes permanent display of this page.
The display is cleared:
- either by selecting another page.
- or by pressing the EXIT button.
2.2.7.10 - AUTO IRIS button
Selection of IRIS operating mode: AUTO or MANUAL.
• Indicator light off: Iris is operating in the MANUAL
mode (the operator controls a complete range of lens
aperture (diaphragms).
• Indicator light lit: The Iris operates in the AUTOMATIC
mode. However, the operator can modify the iris aperture
by ± 1 DIAPH, as defined by the automatic device.
• If the CATCH IRIS = ON operating mode is selected
(refer to Installation chapter: camera configuration), the
indicator light flashes on changeover from AUTO to
MANU as long as the Iris control has not the true aperture
value of the lens Iris.
B1500M24LA
September 2000
PRE ON AIR 1
VIEW
LOCK ACTIV CCU STATUS BARS SETTING
F1 F2 F3
EXIT
CTRL
DIAG
PRESET GAIN FILTERS DETAIL
STORE DFZ BLACK COLOUR
RECALL KNEE SHUTTER GAMMA
BLACK BAL WHITE BAL
LIMIT
ASSIGNED ASSIGNED
GAIN
ASSIGNED ASSIGNED
BLACK
ENABLE AUTO IRIS
THOMSON OCP 42/OCP 50
User manual
145
ON
AIR 2
CALL
F4
NEXT
SKIN MEMORY
LIMIT
FINE
ADJUST