Wilo -Stratos MAXO Notice De Montage Et De Mise En Service page 53

en
▪ The initial settings menu is exited when "Start with factory set-
tings" is activated by pressing the operating button. The display
changes to the main menu. The pump continues to run in the fact-
ory setting.
▪ If venting has been started, other settings can be made in the
meantime.
▪ In the "First settings" menu, settings that can be chosen and adjus-
ted include language, units, applications and setback operation. The
chosen initial settings are confirmed by activating "Finish initial
settings". The display changes to the main menu.
Home screen
1 1.1
Radiator - Differential pressure Δp-v
Delivery head setpoint
1.0
6.1 m
Normal operation
3
Fig. 2: Home screen
Pos. Name Explanation
Main menu Selection of different main menus
1
overview
44
All manuals and user guides at all-guides.com
2 6
Duty point:
6.9
Δp-v
12.0
Q = 10.3 m³/h
H = 2.0 m
Measured values:
T fluid = 68.2 °C
P electr. 160 W
= 42.0 kWh
W electr.
=
Further settings
4 5
Pos. Name
Status area:
Error, warning
or
process in-
formation dis-
1.1
play
Title bar
2
Setpoint dis-
7 3
play field
Setpoint ed-
4 itor
Active influ-
ences
8
5
Reset refer-
ence
6
Explanation
Indicates an on-going process, warning or
error message.
Blue: Process or communication status dis-
play (CIF module communication)
Yellow: Warning
Red: Fault
Grey: There are no processes running in the
background, there are no warning or error
messages.
Display of currently set application and
control mode.
Displays currently configured setpoints.
Yellow frame: You have pressed the operat-
ing button to open the setpoint editor and
change the value.
Display of influences on set control mode
e.g. active setback operation, No-Flow
Stop OFF (see table entitled "Active influ-
ences"). You can display up to five active
influences.
Shows the value before having changed it
when the setpoint editor is active.
The arrow shows that you can go back to
the previous value with the Back button.
WILO SE 2019-11