Assembly - Haussmann N1F-GT-300 Manuel De L'utilisateur

ASSEMBLY

! WARNING! Ensure during assembly that the power cable is not squeezed and
N
O.
that it has sufficient play.
Advice
Observe correct mains voltage: The voltage of the power source must match
the voltage specified on the nameplate of the unit.
Fitting Auxiliary Handle(Fig.3)
1. Place your handle on the tool as shown.
2. Adjust handle to the most comfortable position.
3. Pass the handle knob bolt through auxiliary handle. Screw the handle knob
bolt into the captive nut on the far side of the auxiliary handle.
Fig.3
Fitting the safety guard(Fig.4)
WARNING! The guard must be properly installed. The guard provides partial
!
protection from the risk of thrown objects to the operator and others.
1. Unplug the tool.
2. Remove the screw from the motor housing
3. Put guard in direction of arrow to align with screw hole.
4. Firmly press the guard into place.
5. Secure the guard with screw. Never use the tool unless the guard is properly
fitted.
6