Assembly / Adjustment - Haussmann CGT18L Manuel D'utilisation

OPERATING INSTRUCTIONS
Fig. A4
B
C
When battery charge runs out after
continuously use or exposure to direct
sunlight or heat, allow time for the tool to cool
down before re-charging to achieve the full
charge.
NOTE: This charger is designed to detect
some problems that can arise with battery
pack. (see table below)
Red Flashing
Green Off
Red ON
Green Off
Green ON
Red Off
Green Flashing
Red Off
4. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. A5)
Depress the battery release button to release
Defective battery,
after pre-charge 30
minutes with trickle
current, the total
battery voltage is
still less than 15.0V.
Charging
Power On and Fully
Charged
The temperature
of battery pack is
less than 0°C (32°F)
or more than 45°C
(113°F)
battery pack from your grass trimmer. After
recharging, insert the battery pack into grass
trimmer's battery port. A simple push and
slight pressure will be sufficient.
Fig. A5

ASSEMBLY / ADJUSTMENT

The guard must always be on the tool to
protect the user.
1. Fitting the edge guide wheel
(See Fig. B1)
Select the edge guide wheel. Locate onto
the motor housing. Carefully select the two
fixing screws. Secure in position. Check that
the edge guide wheel is properly located and
secured.
Fig. B1
2. Fitting the guard (See Fig. B2)
Fix the safety guard to the trimmer head,
making sure the sides are located into the
grooves on the trimmer head.
Secure the safety guard onto the trimmer
head with the screw provided.
A
19