Haussmann CGT18L Manuel D'utilisation page 22

OPERATING INSTRUCTIONS
4. Do not overload your trimmer, take small
passes - this will keep your tool operating at
high speed and will greatly improve cutting
efficiency. (See Fig. L and M)
5. Use the edge of the guard as a guide when
using near fences walls etc, and move in a
backward direction, this will save damage.
(See Fig. N and O)
Fig. L
Fig. M
Fig. O
A
22
Automatic line feed system
When initially switching on the trimmer, a small
length of line is fed out.
A 'clattering' noise will be heard when the lines
hit the line cutter. DO NOT BE ALARMED - this
is quite normal. After about 5 seconds the line
will be cut to the correct length and the noise
will reduce as the motor reaches full speed.
If the noise of the line being cut can't be heard,
more line will be fed out.
To feed more line, it is first necessary to allow
the trimmer to stop completely, then restart,
allowing the motor to reach full speed.
Repeat above until you hear the lines hitting
against the line cutter. (Do not repeat this
procedure more than 6 times)
To manually feed the line (See Fig. H)
If required line can be feed out manually.
Before manual feed, remove the battery first.
To operate, press and release manual line
feed button, while gently pulling out the lines
until the lines reach the line cutter.
If the line extends past the line cutter, too
much line has been fed out.
If too much line is fed out, remove the spool
Fig. N
cap and turn spool counter-clockwise until the
line is at the desired length.
To remove the cap
Press and hold in the two latches. (See Fig. P)
Fig. H