Haussmann CGT18L Manuel D'utilisation page 20

OPERATING INSTRUCTIONS
Take great care when doing this as the guard
has a very sharp cutting edge. (See Fig. C)
Never operate the tool without the guard
properly in place. Use of the unit without the
guard will cause the motor to overheat, and
void the warranty.
Fig. B2
Fig. C
3. Fitting the auxiliary handle (See Fig. D)
NOTE: This may already be pre-fitted to the
trimmer. However the following instructions
give full assembly details.
1) Locate the auxiliary handle to the bracket.
Note its orientation.
2) Insert the bolt through the bracket and the
handle and screw into the captivated nut.
Tighten using the large adjustment wheel.
A
Fig. D
20
4. Adjusting auxiliary handle
Unscrew the auxiliary handle locking knob.
Rotate the auxiliary handle to the most
comfortable and balanced position.
Then tighten the auxiliary handle locking
knob.
5. Adjust the height (See Fig. E)
Adjust the main handle to the correct working
length for your physical size. To do this
simply push the height adjustment locking
mechanism and pull / push the lower shaft.
The trimmer handle has a number of preset
positions for this - as you push / pull the lower
shaft release the collar and then push/pull the
lower shaft until it locks on desired position.
Fig. E
6. Adjust the head rotation (See Fig. F)
The cutting face can be changed from
horizontal to vertical. (i.e. for cutting edges).
Pull handle rotation locking mechanism
and turn the top of the shaft 180
clockwise. (The head will only move in one
direction) The motor head will swivel through
180 . Release the collar and the shaft will lock-
o
confirm secure before use!
Fig. F
counter-
o