Haussmann N1F-GT-300 Manuel De L'utilisateur page 10

OPERATION
3) Firmly place the cover on the spool and pull them approx.9 cm out of the
spool. Fig.12.
4) Along the groove slide the string into the hole in the string cover. Fig.13
5) Prepare to assemble the spool into the trimmer.
Third How to assemble the spool
1) Insert the spring into the shroud and thread the string into the hole
as shown in Fig.14.
2) Place the spool cover (3) on the spring and press it firmly down until the
locking devices (4) of the spool cover (3) securely click into place.Fig.15.
Check length of nylon cutting line (Fig.16)
Trimming Edges
1) Pull line (6) to inner edge of outer guard (8). If the line is too short, i.e.more
than 50mm from inside edge of guard, push down the red button (5) and at the
same time pull the line a few centimeters past the edge of the guard. Remove
trimming blade guard (9).
9
Fig.12
Fig.13
Fig.14
Fig.15
Fig.16
(5)