Cutting Grass; Maintenance - Haussmann N1F-GT-300 Manuel De L'utilisateur

Fig.17
Fig.18
Fig.19
!
!
OPERATION
To increase line length
The grass trimmer comes with a full line spool. The line wears down during
work. To feed in new line, switch the machine on and the lines will automatically
elongate. The line will automatically be released by centrifugal force. The
trimmer line will be cut to the right length by the blade on the lime cover.

Cutting grass

1) Move the grass trimmer left and right, keeping it well away from the body. The
trimmer can efficiently cut grass up to a height of 15cm. Cut higher grass in
stages.
2) When using the trimmer hold at an angle of about 20°to the ground and swing
the trimmer from side to side. (Fig.17)
Do not overload the trimmer - cut in small sections, which will greatly improve
efficiency by keeping the trimmer running at a high speed. (Fig.18)
Trimming Edges
1) Guide the grass trimmer along the edge of the lawn. Avoid contacting with
paved surfaces, stone or garden walls, as this will wear the line rapidly.
2) Use the edge of the guard as a guide when cutting near fences and walls,
etc.Moving trimmer in a backwards direction will avoid damage (Fig.19)

MAINTENANCE

WARNING ! Before performing any maintenance or cleaning work, unplug trimmer
from the power source!
WARNING ! Always wear protective gloves during maintenance operations.
Do not carry out maintenance when the engine is running or hot.
10