Haussmann N1F-GT-300 Manuel De L'utilisateur page 5

!
Fig.2
SAFETY INSTRUCTIONS
5) Use Safety Glasses – Always use face or dust mask if operation is dusty.
6) Use Right Appliance – Do not use appliance for any job except that for which
it is intended.
7) Ground Fault Circuit Interrupter (GFCI) protection should be provided on the
circuit(s) or outlet(s) to be used for the gardening appliance. Receptacles are
available having built-in GFCI protection and may be used for this measure of
safety.
WARNING! To reduce the risk of electric shock, use only with an extension cord
intended for outdoor use, such as an extension cord of cord type SW-A, SOW-A,
STW-A, STOW-A, SJW-A, SJOW-A, SJTW-A. or SJTOW-A.
8) Extension Cord – Make sure your extension cord is in good condition. When
using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized extension cord will cause a
drop in line voltage resulting in loss of power and overheating. If in doubt, use
the next heavier gauge. The smaller the gauge number, the heavier the cord.
SELECT AN EXTENSION CORD
Extension Cord Gauge Chart
Length of Cord
25 Ft. (7.5 m)
50 Ft. (15 m)
100 Ft. (30 m)
To reduce the risk of disconnection of appliance cord from the extension cord
during operating:
i) Make a knot as shown in Fig.2;
ii) Use one of the plug-receptacle retaining straps or connectors described in
this manual.
10) Avoid Unintentional Starting – Don't carry plugged-in appliance with finger
on switch.Be sure switch is off when plugging in.
11) Handle cord carefully – Never carry appliance by cord or yank it to
disconnect from receptacle. Keep cord from heat, oil, and sharp edges.
12) Don't Force Appliance – It will do the job better and with less likelihood of
arisk of injury at the rate for which it was designed.
13) Don't Overreach – Keep proper footing and balance at all times.
14) Stay Alert – Watch what you are doing. Use common sense. Do not operate
appliance when you are tired.
15) Disconnect Appliance – Disconnect the appliance from the power supply
when not in use, before servicing, when changing accessories such as
blades, and the like.
16) Keep guards in place and in working order.
17) Keep hands and feet away from cutting area.
Gauge
18 Gauge
16 Gauge
16 Gauge
4