Changes To The Settings - Beurer EM 40 Mode D'emploi

• If an admissible key is pressed, there is one short beep. If an inadmissible key
is pressed, there are two short beeps.
7.2 Procedure for TENS, EMS and Massage programmes 01-10
(quick start)
• From the programme charts, select a programme that is suitable for your
purpose.
• Place the electrodes in the area selected and connect these to
the machine. The corresponding positioning suggestions may
help you here.
• Press the ON/OFF key in order to switch on the machine.
• Press MENU and navigate through the sub-menus (TENS/EMS/
MASSAGE) and confirm your selection with ENTER. (Fig. 1,
example of TENS display)
• Using the UP/DOWN keys, select the programme you want and
confirm with ENTER (Fig. 2, example of display for No. 1 TENS
programme).
• Using the UP/DOWN keys, select the total treatment time and
confirm with ENTER (Fig. 3, example of 30-minute treatment
duration).
The machine is in wait status (Fig. 4).
• Press ON/OFF to start the stimulation treatment. The opera-
tion status display starts to change (Fig. 5).
• Select the pulse intensity which is the most comfortable for
you by pressing the key CH 1+/CH 2+.
The pulse intensity display adapts accordingly.
7.3 Procedure for TENS/EMS programmes 11 to 20
(individual programmes)
Programmes 11 to 20 are preset programmes which you can also individualise.
Here you can set pulse frequency.
• From the programme charts, select a programme that is suitable for your
purpose.
• Place the electrodes in the area selected and connect these to the machine.
The corresponding positioning suggestions may help you here.
All manuals and user guides at all-guides.com
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
25
• Press the ON/OFF key in order to switch on the machine (Fig. 1,
example of TENS display).
• Using the UP/DOWN keys, select the programme you want and
confirm with ENTER (Fig. 2, example of display for No. 11 TENS
programme).
• Using the UP/DOWN keys, select the frequency you want for
Cycle 1 (Hz) and confirm with ENTER (Fig. 3). Repeat this
process for all subsequent cycles.
• To terminate frequency setting, set the frequency (Hz) after
the cycle last required "--0" and press ENTER. All frequency
settings of subsequent cycles are then automatically set at "0"
and thus not taken into account.
Tip: Hold down the ENTER key for 2 seconds in order to
skip frequency settings and access 'treatment time setting' . In
the event that you need all 8 cycles, you can also press ENTER
for 2 seconds to terminate selection of frequency settings.
• Using the UP/DOWN keys, select the desired treatment time
and confirm with ENTER (Fig. 4, example of 30-minute treat-
ment duration).
• The machine is in wait status (Fig. 5).
• Press ON/OFF to start the stimulation treatment. The opera-
tion status display starts to flash (Fig. 6).
• Select the pulse intensity which is the most comfortable for
you by pressing the key CH 1+/CH 2+.
The pulse intensity display adapts accordingly.
Note: Your individualised programme settings are stored and automatically
retrieved when you select it next.

7.4 Changes to the settings

Changing intensity (during application)
• CH1+/- and CH2+/-: Changing the intensity for each channel.
• DOWN key : the intensity of both channels is reduced.
Interrupting stimulation
Press the ON/OFF button.
If you press it again, the application is resumed.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6