10.1.3 Replacement of the wiper blade
In models equipped with a wiper, the worn blades
can be replaced.
Unscrew the rivet nut fastening the blade and
remove it with the washers. Replace the worn
blade with a new one. Apply a good quantity of
threadlocker (Loctite 270), reposition the rivet nut
and the washers by adjusting fastening until the
blade correctly tits to the glass. Activate the wiper to
check the blade is correctly adjusted.
Fig. 25
36
10.2 Extraordinary maintenance
10.2.1 Fuse replacement
CAUTION! To ensure protection against the
risk of fire, replace the fuse with one the
same type and value. The fuse must only
be replaced by qualified staff.
If necessary, replace the fuses illustrated in figure (
6.3 Connector board description, page 28).
FUSES REPLACEMENT MPXHD, MPXR, MPXT
Supply voltage
Fuse (F1)
24Vac, 50/60Hz
T 4A H 250V 5x20
120Vac, 50/60Hz
T 2A H 250V 5x20
230Vac, 50/60Hz
T 2A H 250V 5x20
220Vac, 50/60Hz
T 2A H 250V 5x20
100Vac, 50/60Hz
T 2A H 250V 5x20
Tab. 15
FUSES REPLACEMENT MPXL
Supply voltage
Fuse (F1)
24Vac, 50/60Hz
T 5A H 250V 5x20
120Vac, 50/60Hz
T 2A H 250V 5x20
220Vac/230Vac,
T 2A H 250V 5x20
50/60Hz
100Vac, 50/60Hz
T 2A H 250V 5x20
Tab. 16
Fuse (F2)
T 4A H 250V 5x20
T 4A H 250V 5x20
T 4A H 250V 5x20
T 4A H 250V 5x20
T 4A H 250V 5x20
Fuse (F2)
T 5A H 250V 5x20
T 5A H 250V 5x20
T 5A H 250V 5x20
T 5A H 250V 5x20
MNVCMPXHDC_2222_EN