Breville the Grind Control BDC650 Manuel D'instructions page 32

TROUBLESHOOTING TROUBLESHOOTING
PROBLEM
Amount brewed
is too little / too
much
'DE-SCALE' on
LCD screen
I want to empty the
water tank
BDC650BSS_USC_IB_E20_FA.indd 31
POSSIBLE CAUSES
There is excessive
mineral build-up affecting
the performance of the
machine.
The volume calibrations
need to be reset.
The water tank was filled
once the coffee machine
had already started a
brewing cycle.
The programmed brew
size are approximate
only. Actual amounts
may vary due to the type
of filter used, the coffee
bean size, roast, blend and
freshness, or amount and
type of pre-ground coffee
used. These factors affect
the amount of water
retained by the coffee
grounds.
There is excessive
mineral build-up affecting
the performance of the
machine.
WHAT TO DO
De-scale the machine. Refer to
'Removing Calcium Build-Up',
page 25.
Recalibrate the machine by
flushing it twice. Refer to 'Using
the Grind Control™ - Carafe Mode.
First Time Use Only', page 12.
Always fill the water tank before
starting a brewing cycle.
Remove the 'DE-SCALE' icon
by press and hold the Strength
button for 5 seconds, then de-scale
the machine. Refer to 'Removing
Calcium Build-Up', page 25.
• Select water amount indicated
on the LCD
• Select Pre-ground setting
• Ensure the Carafe is in place
• Press Start/Cancel
• Discard the water when finished
31
24/1/20 9:41 am