Programming The Clock - Breville the Grind Control BDC650 Manuel D'instructions

OPERATING YOUR BREVILLE PRODUCT OPERATING YOUR BREVILLE PRODUCT
To stop the cycle at any time, press the
START | CANCEL button. You will hear
a winding noise. This is normal.
CAUTION
Never open the swing-out door and
remove the coffee basket while brewing.
Hot water and coffee can cause injury.
6. Empty the Coffee Basket
Once the brewing cycle is complete, the ready
signal will sound and a winding noise will be
heard. This is normal.
The coffee machine will automatically shut-off,
however the LCD screen will flash 'EMPTY
COFFEE FILTER' as a reminder to remove
the coffee basket and discard the used grinds.
Wash the coffee basket, taking particular care
to rinse the chute area. Then dry the coffee
basket and chute area thoroughly.
We also recommend checking the coffee
grinds chute disc for any build-up of coffee
grinds. This is the stainless steel disc that is
visible when the swing-out door is opened.
A build-up of grinds on this disc can affect the
performance of the machine. Wipe the disc
clean then dry thoroughly.
7. When Not In Use
LCD screen will dim after 5 minutes of none
operation.
BDC650BSS_USC_IB_E20_FA.indd 17
CAUTION
The coffee basket, gold tone or paper
filter may still be very hot after brewing.
Use caution and allow to cool before
removing.
NOTE
If using the gold tone filter, you may
notice the brewing cycle finish before
the ready signal sounds. This is normal.
The total brewing time displayed on the
LCD screen is calculated using paper
filters as coffee passes through paper
filters slower.

PROGRAMMING THE CLOCK

(OPTIONAL)
1. Press the MENU|EXIT button.
2. Press the STRENGTH dial. The LCD
screen displays the current time,
flashing.
3. Rotate the STRENGTH dial to adjust
the time.
4. Press the STRENGTH button to set.
The machine will beep to confirm.
5. The LCD will return to the main screen
when the clock is set.
17
24/1/20 9:41 am