Zigo LEADER 1083 Serie Manuel De Montage Et D'utilisation page 64

Adjusting Cycle Stem to Steerer Fork alignment
Stem Steer
Clamp Bolts
Stem
Failure to properly tighten the Handlebar Clamp Bolts may
compromise steering action, which could cause you to lose control
and fall. Place the Front Wheel of the bicycle between your legs and
attempt to twist the Handlebar/Stem assembly. If you can twist the
stem in relation to the front wheel or turn the Handlebar in relation
to the Stem, tighten the appropriate Bolts.
Set Carrier Bicycle Steering Alignment
Adjusting the Turnbuckle at the left Hub Steering Plate adjusts Carrier Bicycle
steering alignment.
I. Prepare Carrier Bicycle
1. Adjust steerer fork to stem alignment. See Section 9.7.2 LeaderLink Steering in
your Assembly and Operation Manual
2. Couple the Cycle to the ChildPod to convert to Carrier Bicycle Mode. See
QuickStart Guide.
3. Lower the Cycle seat.
4. Flip over Carrier Bicycle so it is completely upside down.
You will not be able to successfuly align Carrier Bicycle steering
without coupling Cycle to ChildPod.
64
!
WARNING!
NOTE
1. Loosen both bolts
of the Stem Steerer
Clamp one or two
turns.
2. Gently tap Stem with
the palm of your
hand until it points
straight ahead.
3. Re-tighten the two
bolts the same
number of turns that
you loosened them.