Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. From the main menu use the
2. Use the
or
to select Stirring and confirm.
3. To turn on/off the stirrer push
4. When the stirrer is turned on, use the
speed in %.
Note: Use the
or
to change the stirring speed during calibration and during
a measurement.
Change the temperature units
The temperature units can be changed to Celsius or Fahrenheit.
1. From the main menu use the
2. Use the
or
to select Temperature units and confirm.
3. Use the
or
to select between Celsius or Fahrenheit and confirm.
Data logger
Display data
The Display data log contains Measurement data, Electrode report and
Calibration data. The stored data can be send to a printer or to a PC. When
the data log becomes full (400 data points), the oldest data point is deleted
when a new data point is added.
1. From the main menu use the
2. Use the
or
to select DATA LOGGER and confirm.
3. Use the
or
to select Display data and confirm.
4. Use the
or
to select
Option
Description
Measurement data Measurement data—stores automatically each time a
sample is measured
Electrode report
Electrode report—stores automatically the electrode
history and measurement conditions
Calibration data
Calibration data—stores automatically the current
calibration
All manuals and user guides at all-guides.com
or
to select SYSTEM. Confirm.
.
or
to change the stirring
or
to select SYSTEM. Confirm.
or
to select SYSTEM. Confirm.
Delete data
The entire measurement data or electrode report log can be deleted to
remove data that has already been sent to a printer or PC.
1. From the main menu use the
2. Use the
or
to select DATA LOGGER and confirm.
3. Use the
or
to select Erase and confirm.
4. Use the
or
to select Measurement data or Electrode report and
confirm. Confirm again to delete the data.
The entire log is deleted at once.
Send data to a printer or to a computer
N O T I C E
The data output (printer or PC) needs to be selected first, so that the Print menu
is available (refer to
Select the data output
Note: Refer to
Report output
on page 11 to select the report output type.
1. From the main menu use the
2. Use the
or
to select DATA LOGGER and confirm.
3. Use the
or
to select Print and confirm. Select one of the following
options and confirm with
Electrode data, Calibration data, Calibration report or Instrument
condit.
Report output
N O T I C E
The data output (printer or PC) needs to be selected first, so that the Type of report
menu is available (refer to
Select the data output
Different report output types can be selected when a printer or a PC is
connected.
1. From the main menu use the
2. Use the
or
to select Type of report and confirm.
or
to select SYSTEM. Confirm.
on page 10).
or
to select SYSTEM. Confirm.
to print the data: Measurement data,
on page 10).
or
to select SYSTEM. Confirm.
English 11
Publicité
Table des Matières
