Starting Operation - Bosch Professional GBH 36 V-LI Compact Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-589-001.book Page 12 Monday, December 10, 2007 10:29 AM
12 | English
Adjusting the Drilling Depth on the Dust Extrac-
tion Attachment (see figure H)
The required drilling depth X can also be adjusted
when the dust extraction attachment is mounted.
Insert the SDS-plus drilling tool to the stop into
the SDS-plus tool holder 2. Otherwise, the mov-
ability of the SDS-plus drilling tool can lead to in-
correct adjustment of the drilling depth.
Loosen the wing bolt 24 on the dust extraction
attachment.
Without switching the power tool on, apply it
firmly to the drilling location. The SDS-plus drill-
ing tool must face against the surface.
Position the the guide pipe 25 of the dust extrac-
tion attachment in its holding fixture in such a
manner that the head of the dust extraction at-
tachment faces against the surface to be drilled.
Do not slide the guide pipe 25 further over the
telescopic pipe 23 of the dust extraction attach-
ment than required, so that as much as possible of
the scale 23 on the telescopic pipe remains visible.
Retighten the wing bolt 24 again. Loosen the
clamping screw 21 on the depth stop of the dust
extraction attachment.
Move the depth stop 22 on the telescopic pipe 23
in such a manner that the clearance X shown in
the figure corresponds with the required drilling
depth.
Tighten the clamping screw 21 in this position.
Operation

Starting Operation

Inserting the Battery
Use only original Bosch lithium ion batteries
with the voltage listed on the nameplate of
your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
Set the rotational direction switch 6 to the center
position to protect the power tool against acci-
dental starting.
Insert the charged battery 11 from the front into
the base of the power tool. Push the battery com-
pletely into the base until the red stripe can no
longer be seen and the battery is securely locked.
1 619 929 798 | (10.12.07)
Setting the Operating Mode
With the selector switch for drilling/hammer
drilling 8, the operating mode of the machine is
selected.
Note: Change the operating mode only when the
machine is switched off! Otherwise, the machine
can be damaged.
To change the operating mode, turn the selector
switch for drilling/hammer drilling 8 to the re-
quested position.
Position for hammer drilling in con-
crete or stone
Position for drilling without impact
in wood, metal, ceramic and plastic
as well as for screwdriving
Reversing the Rotational Direction (see figure I)
The rotational direction switch 6 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 7 actuated.
Right rotation: Push the rotational direction
switch 6 left to the stop.
Left rotation: Push the rotational direction
switch 6 right to the stop.
For hammer drilling and drilling, always set the
direction of rotation to right rotation.
Switching On and Off
To start the machine, press the On/Off switch 7.
When starting the machine for the first time, a
starting delay is possible, as the electronic sys-
tem of the power tool has to configure itself first.
To switch off the machine, release the On/Off
switch 7.
Setting the Speed/Impact Rate
The speed/impact rate of the switched on power
tool can be variably adjusted, depending on how
far the On/Off switch 7 is pressed.
Light pressure on the On/Off switch 7 results in
low speed/impact rate. Further pressure on the
switch increases the speed/impact rate.
Bosch Power Tools