Technical Data; Rotary Hammer; Battery Charging - Bosch Professional GBH 36 V-LI Compact Notice Originale

OBJ_BUCH-589-001.book Page 9 Monday, December 10, 2007 10:29 AM

Technical Data

Rotary Hammer

Article number
Speed control
Right/left rotation
Rated voltage
Rated power input
Output power
Impact frequency at
rated speed
Impact energy per stroke
Rated speed
Tool holder
Spindle collar diameter
Drilling diameter, max.:
– Concrete
– Steel
– Wood
Max. diameter for
screwdriving
Weight according to
EPTA-Procedure 01/2003
Please observe the article number on the type plate
of your power tool. The trade names of individual tools
may vary.
Assembly

Battery Charging

Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, completely
charge the battery in the battery charger before
using your power tool for the first time.
Bosch Power Tools
All manuals and user guides at all-guides.com
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
GBH 36 V-LI
battery.
Compact
The lithium ion battery is protected against deep
Professional
discharging by the "Electronic Cell Protection
3 611 J03 R..
(ECP)". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
V= 36
W 430
has been automatically switched off. The battery
W 320
can be damaged.
bpm 0 – 4850
Removing the Battery
0 – 1.7
J
The battery 11 is equipped with two locking
rpm 0 – 1500
levels that should prevent the battery from falling
out when pushing the battery unlocking button
SDS-plus
12 unintentionally. As long as the battery is
mm 48
inserted in the power tool, it is held in position
by means of a spring.
mm 18
mm 13
mm 30
mm 6
kg 2.9
To remove the battery 11:
– Push the battery against the base of the
– Pull the battery out of the power tool until a
– Press the battery unlocking button 12 again
Do not continue to press the
WARNING
On/Off switch after the machine
power tool (1.) and at the same time press the
battery unlocking button 12 (2.).
red stripe becomes visible (3.).
and pull out the battery completely.
1 619 929 798 | (10.12.07)
English | 9