Residual Heat Indicator; Operation; Main Power Switch; Setting The Cooktop - Bosch NIT8065UC Manuel D'utilisation Et D'entretien

Residual heat indicator

The cooktop is equipped with a residual heat indicator
for each element. Avoid touching the indicated elements.

Operation

Main power switch

Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key. A beep will sound.
The __ indicator located on top of the On/Off touch key
lights up.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than
20 seconds.
The residual heat indicator remains lit until the elements
have cooled down sufficiently.
the corresponding element symbol.
/ is displayed next to
• œ
Even when turned off, the indicator
the cooktop is hot.
If the pan is removed but the element is not turned off,
the indicator / and the selected power level will flash
• œ
alternately.

Setting the cooktop

This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Select the desired heat level using the symbols 1 to 9.
Heat level 1 = minimum power
Heat level 9 = maximum power
Each heat level has an intermediate level. This level is
marked with the symbol in the touch control zone.
Û
Selecting the heat level
The cooktop must be turned on.
Touch the touch key for the corresponding element.
$
1.
The . indicator lights up.
‹ ‹
Touch the number key for the desired heat level.
2.
/ will stay lit while
• œ
11