Residual Heat Indicator; Operation; Main Power Switch; Setting The Cooktop - Bosch NETP668SUC Manuel

Element
Triple element
ò
Bridge element
à

Residual heat indicator

The cooktop is equipped with a residual heat indicator
for each element. It shows you which elements are still
hot. Avoid touching the indicated elements.
If an is shown on the display, the element is still hot.
•
You could use it, for example, to keep a small quantity of

Operation

Main power switch

Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key. An acoustic signal will
sound. The __ indicator located on top of the On/Off
touch key and the symbols for the cooking zones light
up. . lights up next to the cooking zones. The cooktop
‹ ‹
is ready to use.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Notes
The cooktop switches off automatically when all the
▯
elements have been switched off for more than
20 seconds.
The residual heat indicator remains lit until the
elements have cooled down sufficiently.
displayed next to the corresponding element symbol.
Turning on and off
The element has to be selected.
Add middle heating ring: Touch the Additional Heating key. The
▯
Add outer heating ring: Touch the Additional Heating key again. The
▯
on.
Deactivate: Touch the Additional Heating key again. The
▯
heating ring remains on.
The bridge element combines two individual heating elements into one long griddle zone.
This configuration is ideal for griddles and large pans.
Note: Do not use cookware larger than 17" x 10" (432 x 254 mm).
One of the two elements that belong to the bridge element has to be selected.
Activate: Touch the Bridge Join/Split key. The
▯
heating element displays. Set the desired heat setting. ~ "Setting the cooktop"
If a heat level was set on one of the elements before, this heat level will be used for the
bridge element. If two different heat levels were set on the two elements before, the bridge
element will use heat level
Change heat level: Select one of the two elements that belong to the bridge element and
▯
set the new heat level.
Deactivate: Touch the Bridge Join/Split key.
▯
element remains selected. Setting the heat level to
/ is
• œ
indicator appears;
à
.
‹
appears in both displays. The front heating
‹
food warm or to melt a chocolate coating. As the element
continues to cool, the display changes to
goes out once the element has cooled sufficiently.
The residual heat indicator will automatically come on
after a power failure. The display lights up for
approximately 30 minutes.
The settings will be stored for 4 seconds after turning
▯
off the cooktop. If you turn the cooktop back on during
that time the cooktop will continue with those settings.

Setting the cooktop

This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Select the desired heat level using the number keys
1 to 9.
Heat level 1 = minimum power
Heat level 9 = maximum power
Each heat setting has an intermediate level. This level is
indicated by .5 in the element display and is set by
touching the symbols between the number keys.
Ú
indicator turns on.
ð
indicator turns
ò
indicator turns off. The inner
ò
appears in both
‹
‹ does not split the bridge element.
. The display
œ
9