Setting Word Sync, Digital Filter, Dsd, Etc - Esoteric SA-10 Manuel Du Propriétaire

MODE
1 Repeatedly press the MODE button to select the menu
item to be changed.
WORD
(normal display)
< If you leave the unit idle for 10 seconds, the setting mode will
be cancelled.
2
Use the SKIP buttons (.//) to select the options
within the menu item.
3 Repeatedly press the MODE button until the display
returns normal (or leave the unit idle for 10 seconds) to
exit the setup mode.
Pressing the STOP button also finishes the setup mode.
< Switching off the power without exiting the setup mode may
cause problems. Do not turn the unit off.
< Settings are stored even when power is turned off and the
unit is unplugged. If left unplugged for an extended period,
the settings may be lost.
18

Setting Word Sync, Digital Filter, DSD, etc.

DF DSD
Available menu item and options
WORD
Turns on or off the word sync function.
The WORD button of the remote control unit provides the
same function. See page 17 for details.
DF (digital filter)
Selects the characteristic of the FIR digital filter. Choose
either "Wide" or "Narrow".
Wide
This filter has a slow roll-off characteristic and provides a
smooth immersive sound.
Narrow
This filter has a sharp roll-off characteristic and provides
deep, well-defined sound.
DSD
Select "Normal (factory default)" to output DSD after
processing and "Direct" to output the audio signal without
running it through the processor.
The analog level in the Direct mode is 3 dB lower than in the
Normal mode.
(i.LINK)
After a future hardware upgrade (charged), the i.LINK
output setting will be added to this section.
< The i.LINK button of the remote control unit provides the
same function. See page 23 for details.
(Normal display)
Exit the setting mode.