Battery Status; Thorough Cleaning - Cembre B-TC026 Notice D'utilisation Et Entretien

51
82
47
38
37
46
41
42
40
41
41
42
49
40
39
48
48
50
66
TABLE 2 - TABLEAU 2 - TABELLE 2 -
TABLA 2 - TAVOLA 2
04
52
36
34
35 33
03
62
63
02
43
74
75
43
44
45
42
200
205
56
55
45
47
42
54
41
08
61
31

2.5) Battery status

After releasing the operating button, the residual battery
capacity is automatically displayed for 5 seconds on the
indicator (04).
The number of LEDs illuminated indicates the residual
capacity:
10 LEDs illuminated: fully charged
5 LEDs illuminated: 50 % capacity
1 LED illuminated: minimum charge
3. WARNING
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO
COOL DOWN FOLLOWING UNINTERRUPTED
,
INSTANCE HAVING EXHAUSTED A FULLY CHARGED BATTERY IN ONE SESSION
BATTERY REPLACEMENT FOR A FEW MINUTES
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER
.
SUPPLY
D
O NOT USE THIS TOOL ON LIVE CABLES
P
ROTECT THE TOOL FROM RAIN AND MOISTURE
. E
BATTERY LECTRO
RAIN OR UNDER WATER
3.1) Using the battery charger
Carefully follow the instructions in the battery charger manual.
3.2) General information on how to use batteries
In order to use the batteries correctly, please follow these rules:
– Use the battery until the automatic residual energy display still has 1-2 LEDs showing:
this means the battery is almost completely discharged and no loss in the life of the
battery has been caused.
12
– Be particularly careful when charging a new battery the fi rst 2-3 times in order to be
certain of maximising the available energy level.
78
– Allow the battery to cool down to ambient temperature prior to recharging.
– Rest the battery charger for at least 15 minutes between charges.
65
79
4. MAINTENANCE
77
The tool is robust, completely sealed, and requires very little daily maintenance.
201
Compliance with the following points should help to maintain the optimum performance
of the tool:

4.1) Thorough cleaning

Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any
residual particles, especially close to pivots and moveable parts.
4
04
,
SUCCESSIVE CUTTING OPERATIONS
.
.
. W
ATER WILL DAMAGE THE TOOL AND
-
HYDRAULIC TOOLS SHOULD NOT BE OPERATED IN POURING
.
ENGLISH
;
FOR
,
DELAY