Battery Status; Thorough Cleaning - Cembre B-TC065 Notice D'utilisation

Table des Matières

Publicité

ENGLISH

2.5) Battery status

After releasing the operating button, the residual battery
capacity is automatically displayed for 5 seconds on the
indicator (04).
The number of LEDs illuminated indicates the residual
capacity:
10 LEDs illuminated: fully charged
5 LEDs illuminated: 50 % capacity
1 LED illuminated: minimum charge
3. WARNING
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO
COOL DOWN FOLLOWING UNINTERRUPTED
,
INSTANCE
HAVING EXHAUSTED A FULLY CHARGED BATTERY IN ONE SESSION
BATTERY REPLACEMENT FOR A FEW MINUTES
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER
.
SUPPLY
D
O NOT USE THIS TOOL ON LIVE CABLES
P
ROTECT THE TOOL FROM RAIN AND MOISTURE
. E
-
AND BATTERY
LECTRO
HYDRAULIC TOOLS SHOULD NOT BE OPERATED IN POURING
.
RAIN OR UNDER WATER
3.1) Using the battery charger
Carefully follow the instructions in the battery charger manual.
3.2) General information on how to use batteries
In order to use the batteries correctly, please follow these rules:
– Use the battery until the automatic residual energy display still has 1-2 LEDs showing:
this means the battery is almost completely discharged and no loss in the life of the
battery has been caused.
– Be particularly careful when charging a new battery the fi rst 2-3 times in order to be certain
of maximising the available energy level.
– Allow the battery to cool down to ambient temperature prior to recharging.
– Rest the battery charger for at least 15 minutes between charges.
4. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance
of the tool:

4.1) Thorough cleaning

Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any
residual particles, especially close to pivots and moveable parts.
04
,
;
SUCCESSIVE CUTTING OPERATIONS
FOR
,
DELAY
.
.
. W
ATER WILL DAMAGE THE TOOL
5
7
32
30
66
87
50
46
42
49
82
86
TABLE 3 - TABLEAU 3 - TABELLE 3 - TABLA 3 - TAVOLA 3
34
6
7
8
6
10
200
11
200
48
51
38
47
40
*

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

B-tc065a

Table des Matières