Starting Use - Beurer EM 59 Heat Mode D'emploi

2. Then insert the mains adapter into a suitable socket.
3. Alternatively, you can charge the device using your computer/
laptop. To do so, connect the device to a USB
port on your PC/laptop via the USB charging
cable. You cannot use the device while it is being
charged.
4. Turn the belt clip if required.
5. Guide the connection cable plugs into the socket
on the bottom of the device (Fig. 3).
6. Do not pull, twist or kink the cables (Fig. 4).
7. Now attach the supplied gel pads to the
electrodes.
Remove one of the protective films carefully
(Fig. 5).
Carefully attach the gel pad to the electrodes and
carefully detach the protective film (Fig. 6). Ensure
that the edge of the gel pad does not protrude over
the electrode. Applying gel pads slightly askew will
not affect the function.
WARNING!
Remove the protective film slowly and carefully.
Make sure that the self-adhesive gel fpad is not
damaged, as damage or unevenness on the gel pad
may cause skin irritation.
5. Use
5.1 Notes on use
• The device switches itself off automatically if it is not used for
one minute (automatic switch-off). When the unit is switched on
again, the LCD screen displays the menu selection and the most
recently used menu flashes.
• A brief acoustic signal is output when a valid button is pressed.
Two brief acoustic signals are output when an invalid button is
pressed.
• You can pause the stimulation at any time by briefly pressing the
ON/OFF button . To continue the stimulation, briefly press the
ON/OFF button
again.

5.2 Starting use

Step 1: Look for a suitable program from the program tables
Fig. 3
(see section "7. Program overview").
Step 2: Place the electrodes on the desired area for treatment (for
positioning suggestions see section "7.4 Information regarding the
positioning of electrodes") and connect them to the device.
Step 3: Press the ON/OFF button
Fig. 4
Step 4: Press the MENU button to navigate through the
/
your selection.
Step 5: Use the
you want and press the ENTER button to confirm your selection.
Fig. 5
At the start of the stimulation treatment, the impulse intensity of
and
electrodes yet.
Step 6: Use the left and right
to select the impulse intensity you want. The indicator for impulse
Fig. 6
intensity in the display changes accordingly. If the program is in a
pause phase, the intensity cannot be increased.
Step 7: You can activate the heat function using the heat function
button. The first press of the button activates the low heat level,
the second button press activates the high heat level, and the third
button press deactivates the heat function.
26
again and set the desired impulse intensity
to switch on the device.
menus and press the ENTER button to confirm
˄/˅
setting buttons to select the program number
is set to 00 by default. No impulses are sent to the
˄/˅
setting buttons for
/
and